Skip to main content

Research Repository

Advanced Search

The effectiveness of respiratory protection worn by communities to protect from volcanic ash inhalation. Part I: Filtration efficiency tests

Mueller, W.; Horwell, C.J.; Apsley, A.; Steinle, S.; McPherson, S.; Cherrie, J.W.; Galea, K.S.

The effectiveness of respiratory protection worn by communities to protect from volcanic ash inhalation. Part I: Filtration efficiency tests Thumbnail


Authors

W. Mueller

A. Apsley

S. Steinle

S. McPherson

J.W. Cherrie

K.S. Galea



Abstract

During volcanic eruptions and their aftermath, communities may be concerned about the impacts of inhaling volcanic ash. Access to effective respiratory protection (RP) is therefore important for many people in volcanic areas all over the world. However, evidence to support the use of effective RP during such crises is currently lacking. The aim of this study was to build the first evidence base on the effectiveness of common materials used to protect communities from ash inhalation in volcanic crises. We obtained 17 forms of RP, covering various types of cloth through to disposable masks (typically used in occupational settings), which communities are known to wear during volcanic crises. The RP materials were characterised and subjected to filtration efficiency (FE) tests, which were performed with three challenge dusts: ashes from Sakurajima (Japan) and Soufrière Hills (Montserrat) volcanoes and aluminium oxide (Aloxite), chosen as a low-toxicity surrogate dust of similar particle size distribution. FE tests were conducted at two concentrations (1.5 mg/m3 and 2.5 mg/m3) and two flow rates (equivalent to 40 and 80 l/min through 15.9 cm2 sections of each RP type). Each material was held in a sample holder and PM2.5 dust concentrations were measured both outside the mask material and inside the sample holder to determine FE. A limited number of tests were undertaken to assess the effect on FE of wetting a bandana and a surgical mask, as well as folding a bandana to provide multiple filter layers. Overall, four RP materials performed very well against volcanic ash, with median FEs in excess of 98% (N95-equiv., N99-equiv., PM2.5 surgical (Japan), and Basic flat-fold (Indonesia)). The two standard surgical masks tested had median FEs of 89–91%. All other materials had median FEs ranging from 23 to 76% with no cloth materials achieving >44%. Folding a bandana resulted in better FE (40%; 3× folded) than single-layered material (29%). Wetting the bandana and surgical mask material did not improve FE overall. This first evidence base on the FE of common materials used to protect communities in volcanic crises from ash inhalation has been extended in a companion study (Steinle et al., 2018) on the total inward leakage of the best-performing masks when worn by human volunteers. This will provide a complete assessment of the effectiveness of these RP types.

Citation

Mueller, W., Horwell, C., Apsley, A., Steinle, S., McPherson, S., Cherrie, J., & Galea, K. (2018). The effectiveness of respiratory protection worn by communities to protect from volcanic ash inhalation. Part I: Filtration efficiency tests. International Journal of Hygiene and Environmental Health, 221(6), 967-976. https://doi.org/10.1016/j.ijheh.2018.03.012

Journal Article Type Article
Acceptance Date Mar 27, 2018
Online Publication Date Apr 22, 2018
Publication Date Jul 1, 2018
Deposit Date Jun 18, 2018
Publicly Available Date Mar 29, 2024
Journal International Journal of Hygiene and Environmental Health
Print ISSN 1438-4639
Publisher Elsevier
Peer Reviewed Peer Reviewed
Volume 221
Issue 6
Pages 967-976
DOI https://doi.org/10.1016/j.ijheh.2018.03.012

Files






You might also like



Downloadable Citations